John Deere K Series Air-Cooled Engines — REBORE CYLINDER BLOCK

Cylinder Block, Valves and Internal Components/Rebore Cylinder Block REBORE CYLINDER BLOCK NOTE: The cylinder block can be rebored to use 0.25 or 0.50 mm (0.010 or 0.020 in.) oversize pistons and rings. Have a reliable repair shop rebore the block to initial and final bore specifications. The repair shop must have proper equipment to handle cylinders made of high silicon content aluminum. MX,2020A1,A33 -19-21OCT92 CTM5 (20OCT92) 20-20-19 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=80 NOTE: A bare block is available for service. 5. Measure cylinder bore parallel with crankshaft and right angles to crankshaft at top and bottom of ring travel. -UN-23FEB89 6.

If cylinder bore exceeds wear limit, replace cylinder block or rebore cylinder. (See this group.) NOTE: If cylinder is rebored, oversize piston and rings must be installed. M51745 7. Install crankshaft. CYLINDER BORE SPECIFICATIONS Standard Wear Limit FA130D 61.98—62.00 mm 62.07 mm -UN-11MAR91 (2.442—2.443 in.) (2.446 in.) FA210D 71.98—72.00 mm 72.06 mm (2.834—2.835 in.) (2.837 in.) M80267 MX,2020A1,A32 -19-21OCT92 20 20 19