Cylinder Block, Valves and Internal Components/Inspect and Replace Governor 4. Slowly slide float down shaft until needle of multimeter swings to 0 ohms. Measure distance (A) with float at point where needle rapidly moves from infinite resistance to 0 ohms. Replace switch if not according to specification. TY15055 -UN-02SEP88 5. Install cover. 20 20 21 SPECIFICATIONS Distance (A) . . . . . . . . . . . . . . . . . 9.5—15.5 mm (0.374—0.610 in.) M98,2045A,A12 -19-21OCT92 INSPECT AND REPLACE GOVERNOR IMPORTANT: Removal damages governor. If not damaged, do not remove. 1. Remove crankcase cover. (See this group.) M51762 -UN-07SEP88 2. Inspect governor.
If necessary to replace, remove with screwdriver. 3. If removed, press shaft (C) back into block until it protrudes 32.2—32.8 mm (1.267—1.291 in.). NOTE: Assemble sleeve and gear before installing assembly on shaft. 4. Install sleeve (A) onto governor gear (B). 5. Install governor assembly onto shaft. Push down on assembly until it snaps into place. MX,2020A1,A36 -19-21OCT92 CTM5 (20OCT92) 20-20-21 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=82