John Deere K Series Air-Cooled Engines — GOVERNOR ADJUSTMENT—FA130D-AS16/AS19 AND FA210D-AS20

Cylinder Block, Valves and Internal Components/Governor Adjustment GOVERNOR ADJUSTMENT—FA130D-AS16/AS19 AND FA210D-AS20 NOTE: Fuel tank is removed for photo clarity only. 1. Move throttle control lever (A) to fast position. M80364 -UN-17MAY91 2. Loosen nut (C). 3. Hold governor arm fully clockwise. 4. Using a small pin, rotate shaft (B) clockwise as far as it will go. 5. Tighten nut. MX,2020A1,A38 -19-21OCT92 CTM5 (20OCT92) 20-20-22 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=83 INSPECT AND REPLACE GOVERNOR SHAFT NOTE: It is not necessary to remove governor shaft unless damaged. -UN-11MAR91 1. Remove crankcase cover. (See this group.) 2. Inspect shaft (A). Replace if damaged.

3. To replace shaft, loosen nut (E) on lever (D). M80269 4. Remove retaining pin (C), governor shaft and washer (B). A—Governor Shaft 5. Install washer, shaft and retaining pin. Tighten nut. B—Washer C—Retaining Pin D—Governor Lever 6. Install crankcase cover. E—Nut MX,2020A1,A37 -19-21OCT92 20 20 22