Deutz — Checking the axial clearance of the crankshaft

Crankshaft TCD 2013 2V W 05-05-03 ●Remove crankshaft. W 05-05-01 ●Set micrometer gauge to 38 mm. ●Push the internal measuring device between the test surfaces of the micrometer gauge and set to "0". 6 © 35825-2 ●Measure locating bearing width ●Note measured value, dimension (a). © 42606-0 ●Place thrust ring halves on bearing caps (arrows). ●Measure width with micrometer gauge. ●Note measured value, dimension (b). © 35827-2 © 02/2010 OBJ_DOKU-21760-001.fm 3/6