Connecting rod TCD 2013 2V W 06-01-01 Removing the big end bearing cap ●Set lifting journal at bottom dead centre (BDC). ●Unscrew screws (1). ●Remove big end bearing cap (2). ●Remove bearing shell. Lay out components in the order in which they should be installed. Note order of cylinders. 1 2 6 © 44248-0 ●Press out the piston and connection rod. Lay out components in the order in which they should be installed. Note order of cylinders. © 44249-0 ●Remove con rod bearing shells (1). ●Visually inspect the components. 1 © 44250-0 © 02/2010 OBJ_DOKU-21761-001.fm 2/8