Deutz — Removing and installing the piston and con rod

Connecting rod TCD 2013 2V W 06-01-01 ●Set lifting journal at bottom dead centre (BDC). ●Push piston and con rod completely into cylinder lin - er. Note the cylinder assignment of the piston. Note the label indicating the installation position on the piston base. The symbol flywheel/crankshaft (1) must face the flywheel. The piston ring compressor must lie flat on the cylinder liner. 1 6 © 44256-0 ●Press the con rod carefully against the lifting journal. Attention! Do not jam the con rod with the crankshaft. © 44257-0 Installing the big end bearing cap ●Mount big end bearing cap. Attention! Note the assignment of the big end bearing cap.

The identification numbers (1) on the con rod and the big end bearing cap must be identical and opposite to each other when assembled. © 44258-0 © 02/2010 OBJ_DOKU-21761-001.fm 6/8