Connecting rod TCD 2013 2V W 06-01-02 Diagram for measuring the inside diameter of the con rod bearing shells at the points "a" and "b" in the levels "1" and "2". 6 © 37239-1 ●Insert internal measuring device. ●Balance the internal measuring device at the given measuring points and read off the measured value at the reversal point of the pointer. 72,5 mm + 0.02 0 When the wear limit is reached the con rod must be replaced. ●Note the measured value, dimension (C). © 44219-0 ●Checking the diameter of the lifting journals. W 05-05-02 ●Check con rod bearing clearance.
0,036 - 0,095 mm The big end bearing clearance is given by the difference between the internal diame - ter of the big end bearing shell (C) and the lifting journal diameter (D). ●Remove screws. ●Remove the con rod bearing cover. © 42604-0 © 02/2010 OBJ_DOKU-21762-001.fm 7/8