Deutz — Assembling/disassembling shaft sleeve on the crankshaft (opposite side to flywheel)

Front cover TCD 2013 2V W 01-02-02 Attention! Do not damage the peripheral surfaces and the sealing surfaces. ●Join the impact sleeve (1) and the shaft sleeve (2). ●Place the shaft sleeve with impact sleeve centrally on the crankshaft with the collar (3) facing the crank - shaft. 6 © 39872-0 ●Knock the shaft sleeve onto the crankshaft up to the stop by hitting the impact sleeve (1) lightly in the cen - tre. ●Knock on the shaft sleeve evenly all round. The installation depth of the shaft sleeve is determined by the impact sleeve. The shaft sleeve must cover the running marks. © 39891-0 After installing the shaft sleeve, check that there is no burr on the surface of the crankshaft.

●Oil the crankshaft journal lightly. To avoid dust and dirt deposits, do not wet the crankshaft sealing ring and fleece ring with lubricating oil. The manufaturer has already coated the sealing lip with a lubricating wax. ●Install a new crankshaft sealing ring. W 01-02-01 © 39875-0 © 02/2010 OBJ_DOKU-21746-001.fm 2/4