MAINTENANCE SECTION 2 Page 39 1. Stop the engine and tighten up corrosion resistor (coolant filter) valve (1). 2. Turn cap (2) slowly until it comes off. 3. Open drain valve (3) at the bottom of the radiator and plug (4) on the under side of water pump to drain off the cooling water. 4. Brain off all the water, then close up drain valve (3), plug (4), and pour in soft water (ex: city water) up to the vicinity of the water filler. 5. When the water reaches the vicinity of the water filler, pout the engine at low idling, open drain valve through the cooling system for 10 minutes. * When doing this, adjust the inflow and outflow of water so that the radiator is always full. 6.
After flushing with water, stop the engine. Close drain valve (3) and drain plug (4) after draining water. 7. After draining water, use a flushing agent to clean. * We recommend the use of Komatsu genuine goods as the flushing agent. Follow the instructions on the label of the flushing agent to clean the system. After washing the cooling system, drain off all the water. then close UD drain valve (3) and DIUCI (4). and pour in soft water (ex: city water) up to ihe vicinity of the water filler. a. 9.
When the water reaches the vicinity of the water filler, put the engine at low idling, open drain valve (3) and plug (4), then pass water through the cootina svstem until clean water comes out from drain-vaive (3) and plug (4) * When doing this, adjust the inflow and outflow of water so that the radiator is always full.