SECTION 2 Page 47 MAINTENANCE CHECK AND REFILL WINDOW WASHING FLUID Check the washing fluid level in washer tank (1). When the fluid has run short, add automotive window washing fluid. * To prevent the nozzles from clogging, be careful not to let dust get into the fluid. REPLAClNG BUCKET TEETH When the bucket teeth are worn, replace them as follows. IF THE BUCKET EQUIPPED WITH BOLT-ON TOOTH. Raise the bucket to a convenient height, and put blocks under the bucket to prevent it from coming down. Remove the bolts and nut (l), (3) then remove the bucket tooth (2). Raise the bucket so that the bottom is horizontal. install the new teeth on the bucket.
When installing the teeth, insert the shim so that there is no clearance between teeth and top surface of the bucket. Thickness of shim is 0.5 mm. So the clearance should be less than 0.5 mm. To prevent any clearance between the tooth and the edge of the bucket, tighten the nut partially, then hit the tip of the tooth with a hammer. Tightening torque of mounting bolt: mounting bolt (1): 92 t 4 kgm mounting bolt (3): 63 + 3 kgm After operating the machine for a few hours, tighten the mounting bolts again.