SECTION 2 MAINTENANCE Page 48 IF THE BUCKET EQUIPPED WITH TIP TOOTH Replace the teeth before they wear down as far as the adaptor. 1. Extract pin (2) fitted to the bucket and then remove tooth (1). * When extracting pin (Z), strike the part (either the left or right part) with a sharp object. This will enable the pin to be extracted from the opposite side. 2. Insert the new tooth (1) into the adaptor (3), and insert pin (2) partway as shown in the diagram. Then drive it home by means of a hammer. IF THE BUCKET EQUIPPED WITH BOLT-ON CUTTING EDGE REVERSING AND REPLACING BOLT-ON CUTTING EDGE If the bolt-on cutting edge is worn, turn the edge. 1.
Raise the bucket to a convenient height, and put blocks under the bucket to orevent it from coming down. l Raise the bucket so that the bottom is horizontal. 2. Loosen nut (1) and remove bolt (2). Then turn the cutting edge. 3. Exchange cutting edges (3) and (4). and install edge (5) in the opposite direction. 4. After exchanging, tighten with bolts (2) and nuts (1). l Tightening torque. 76 ? 11 kgm . * When installing the edge to the bucket, clean the mounting surface. After the edge has been turned once, replace it with a new part.