Cummins — ADJUSTING PARKING BRAKE

MAINTENANCE SECTION 2 Page 49 ADJUSTMENT ADJUSTING PARKING BRAKE If the effect of the parking brake is poor, adjust as follows. Turn the parking brake swiEh to OFF, release the parking brake and release caliper (1). Turn adjustment bolt (3) of caliper lever (2) to clockwise so that pad (4) is in contact with disc (5) lightly. If adjustment bolt (3) is turned until pad (4) comes into contact with disc (5) tightly, it causes brake noise and heat generation on disc. Turn adjustment bolt (3) one click to counter- clockwise. The total clearance (a + b) on the both side between pad (4) and disc (5) becomes 0.3 to 0.6 mm.

WARNINGI When adjusting, always put blocks under the tires to prevent the wheels from moving. WARNING1 To prevent the parking brake from being applied automatically during adjustment, raise the air prea- sure, and put a warning tag on the parking brake switch to prevent other people from touching it. ‘Srlhen the pad wears to a thickness of less than 8 mm (including backing plate), replace the pad. * Replace two pads as one set, and replace the retraction plate at the same time. * Have the pads replaced by your distributor. WARNING! Do not get any oil or grease on the surface of the brake pad or disc.