Cummins — FUEL, COOLANT AND LUBRICANTS

MAINTENANCE SECTION 2 Page 57 (2) If an engine is operated in ambient temperatures consistently below -23°C [-lO”F] and there are no provisions to keep the engine warm when it is not in operation, use a synthetic CE/SF engine oil with adequate low temperature properties such as 5W-20 or 5W-30. The oil supplier must be responsible for meeting the performance service specifications * The use of a synthetic base oil does not justify extended oil change intervals. Extended oil change intervals can decrease engine life due to factors such as corrosion, deposits, and wear. Special “break-in”; engine lubricating oils are not recommended for new or rebuilt Cummins engines.

Use the same type oil during the “break-in” as that which is used in normal operation. * A sulfated ash limit of 1.85 percent has been placed on all engine lubricating oils recommended for use in Cummins engines. Higher ash oils can cause valve and/or piston damage and lead to excessive Oil consumption. Additional information regarding lubricating oil availability throughout the world is available in the E.M.A. Lubricating Oils Data Book for Heavy Duty Automotive and Industrial Engines. The data book may be ordered from the Engine Manufacturers Association, One Illinois Center, 111 East Wacker Drive, Chicago, IL U.S.A 60601 The telephone number is: (312) 644.6610.

(4) For axle oil, use only recommended oil as follows. (3) Use API classification CD as engine oil and if API classification CC, reduce the engine oil change interval to half. SHELL: DONAX TT OT TD CALTEX: RPM TRACTOR HYDRAULIC FLUID CHEVRON: TRACTOR HYDRAULIC FLUID TEXACO: TDH OIL MOBIL. MOBIL AND SUPER UNIVERSAL * It is possible to substitute engine oil CLASS-CD SAE30 for axle oil. if noise comes from the brake, it is no problem of durability. (5) Cummins recommends the use of ASTM No. 2D fuel. The use of No. 2 diesel fuel will result in optimum engine performance. At operating temperatures below 0°C [32”F], acceptable performance can be obtained by using blends of No. 2 D and No. 1 D.

the use of lighter fuels can reduce fuel economy. The viscosity of the fuel must be kept above 1.3 cSt to provide adequate fuel system lubrication. For a more detailed description of fuel properties, refer to Fuel For Cummins Engines, Bulletin No. 3379001. WARNING! Do nor mix gasoline or alcohol with diesel fuel. This mixture can Cause an explosion. (6) Heavy duty diesel engines require a balanced coolant mixture of water, antifreeze, and supplemental coolant additives (supplementai coolant additive recommendations are included in the Section). Drain and replace the mixture every 2 years, 6,000 hours of operation, whichever occurs first.

In climates where the temperature is above -37°C [-34”F], use a coolant mixture that contains 50 percent antifreeze. Antifreeze is essential in any climate. It broadens the operating temperature range by lowering the coolant freezing point and by raising its boiling point. Do not use more than 50 percent antifreeze in the mixture unless additional freeze protection is required. Never use more than 68 percent antifreeze under any condition. DCA4 is recommended for use in all Cummins engines.

Use low silicate antifreeze which meets Engineering Standard GM 6038-M or which contains no more than 0.1 percent anhydrous alkali metasiiicate and meets either Engineering Standard 1828-M or GM 1899-M which are performance specifications. Use soft water in the coolant mixture. Contaminants in hard water neutralize the corrosion inhibitor components. Water must not exceed 300 ppm hardness or contain more than 100 ppm chloride or sulfate Maintain supplemental coolant additive levels at I unit DCA4 per 3.8 liters [l U.S. gallon] Of Coolant.