s TV A SECTKIN 3 Page 19 * When installing car radio and a walkie-talkie or citizen band, contact your distributor. * When washing the machine, take care not to splash water over the electrical equipment If it is soaked with water, it may not operate normally. * After dlsconneciing the connector, Cover it with a vinyl bag to prevent oil or dust from sticking to its contact ssction. * When weiding, be careful of the following: 23 Do net contrwousiy apply more than 200 u 1) Turn QFF the power (starting switch). 3) Instail the ground cabie at least 1 m from Yhe range to be welded 4) Take care riot to install the seals between the grounded point and the range to be welded.
E Use ordinary automobile washer fluid Be careful not to let dirt or dust get in. T ~~A~~ Various types of ~tt~ohrneRts are availab!e lo extend the range of application beyond the application described beiow. EXCAVATION When loading piled soil or blasted rock, drive the machine fonwrd as follows to load. To prevent cutting of the tires caused by the tires slipping, be careful of the following points during the operation. Always keep the operating jobsite flat, and remove any fallen rocks. When working with stockpiles, operate the machine in 1st or 2nd, operate the machine in 1st when loading blasted rock.
When driving the machine forward and iowering the bucket, stop the bucket about 30 cm from the ground, then lower it slowly. If the bucket hits the ground, the front tires will come off the ground. and the tires will slip. Shift down immediately in front of the material to be loaded When completing the shift down, depress the accelerator pedal at the same time and thrust the bucket into the load.