SECTION 3 Page 20 SAFETY AND OPERATION When the material is in a stockpile, keep the cutting edge of the bucket horizontal; when loading blasted rock, have the bucket tilting slightly down Be careful not to get blasted rock under the bucket. This will make the front tires come off the ground and slip. Try to keep the load in the center of the bucket, if the load is on one side of the bucket, the load will be unbalanced. At the same time as thrusting the bucket into the material, raise the lift arm to prevent the bucket from going in too far. By raising the lift arm, ample traction will be produced by the front tires.
Check that there is enough material loaded into the bucket, then operate the bucket control lever to tilt the bucket and load the bucket fully. If the bucket edge is moved up and down while pushing in the bucket and digging, the front tires will come off the ground and this will cause the tires to slip.