Cummins — EXCAVATION

OPERATION SECTION 3 Page 21 6 If there is too much material loaded in the bucket, dump and tilt the bucket quickly to remove the excessive load. This prevents spillage of the load during hauling. * When digging and loading on level ground, set the bucket edge facing down slightly as follows and drive the machine forward. Always be careful not to load the bucket on one side and cause an unbalanced load. * This operation should be carried out in 1 st gear. 1. Set the edge of the bucket facing slightly down. 2. Drive the machine forward and operate the lift arm control lever forward to cut a thin layer of the surface each time when excavating the soil.

3 Operate the lift arm control lever slightly up and down to reduce the resistance when driving the machine forward. When drgging with the bucket. avoid imposing the digging force onto only one side of the bucket WARNING! Never dig or scoop when the machine body is articulated. Precautions when scooping up material. When scooping up materials, be careful not to let the counterweight at the rear touch the ground * Do not allow tires slipping to occur during operation Trres slipping shortens tire‘s life