Cummins — AFTER STORAGE

SECTION 3 Page 32 SAFETY AND OPERATION STORAGE BEFORE STORAGE To place the machine in storage for an extended period of time, the following measures must be taken to insure that it can be returned to operation with minimum of service. - After every part is washed and dried, the machine shall be housed in a dry building. Never leave it outdoors. In case it is indispensable to leave it outdoors, lay wood plates on the ground, and park the machine on the wood plates and cover it with canvas etc.

* Completely fill fuel tank, lubricate and change oil before storage - Apply a thin coat of grease to metal surface (hydraulic piston rods and splined shaft) * As to batteries, remove the terminals and cover them, or remove them from the machine and store separately. l Set each control lever to neutral or hold position, lock them and apply the parking brake. DURING STORAGE - Operate the engine and move the machine for a short distance once a month so the new Oil film will be coated over movable parts and component surfaces.

- Before operating the work equipment, wipe off the grease on the hydraulic piston rod A WARNINGI If it is unavoidably necessary to carry out rust-preventive operation while the machine is indoors, open up doors and windows to improve ventilation and prevent the gas poisoning. AFTER STORAGE Carry out the following procedure wher, taking the machine out of long-term storage. * Wipe off the grease on the hydraulic piston rod - Completely fill fuel tank, lubricate and add oil. * If the machine Is stored without carrying out the monthly rust prevention operation, request Your distributor for service.