SAFETY AND OPERATION SECTION 3 Page 31 TRANSPORTATION When transporting the machine, observe the various road rules, road transportation vehicle limit ordinances, etc. It is a good idea to obtain a special platform for loading and unloading the machine. When it is unavoidably necessary to use a gangplank, however, at the very least observe the fOIloWing for the sake of safety. 1. Properly apply the brakes on the trailer and insert blocks beneath the tires to ensure that it does not move. The fix the gangplank in line with the centers of the trailer and the machine. * Make sure the gangplank has sufficient width, length and thickness to enable the machine to be safely loaded and unloaded. 2.
Determine the direction of the gangplank, then slowly load or unload the machine. If the gangplank sags appreciably. reinforce it with blocks, etc. * When transmission cut-off switch is put in OFF, the left brake pedal and accelerator pedal are operated at the same time. A WARNING! Remove the mud from the undercarriage to prevent the machine from slipping to the side on slopes. A WARNING! Do not on any account change the direction of the machine while it is on the gangplank. To change the direction of the machine, first take it down from the gangplank. Correctly load the machine onto the specified part of the trailer. Lower the bucket and lock each control lever using safety lock.
Lock front frame and rear frame with safety bar When transporting the machine, place blocks underneath the front and rear wheels to prevent the machine from moving about Also, hold it down with chains or wire ropes. Determine the route for transporting the machine by taking into account the width, height and weight of the machine. WARNING! When loading the machine, park the trailer on a flat, firm roadbed. Keep a fairly long distance between the road shoulder and the machine.