Cummins — STARTING ENGINE WITH A BOOSTER CABLE

SECTION 3 Page 30 SAFETY AND OPERATION STARTING ENGINE WITH A BOOSTER CABLE When starting up the engine with a booster cable, do as follows: 1. Before connecting the booster cable 1) Size of booster cable and clip should be suitable for the battery size. 2) Check cables and clips for breaks, corroded surfaces, etc. 3) Make sure cables and clips are firmly secured. 5) The battery of the running engine must be the same capacity as that of engine to be started. 4) Keep the starting switch in “OFF” position. 2. Connect the booster cables in the following manner. 1) Connect one clip of booster cable A to the positive (+) terminal of the engine to be started.

2) Connect the other clip to the positive (t) terminal to the engine which is running. 3) Connect one clip of booster cable B to the negative (-) terminal of the engine which is running. 4) Connect the other clip to the engine block to be started. l Make sure the clips are firmly connected to battery terminals. Then, start the engine. A WARNINGI When connecting the cables, never contact the positive (+) and negstive (-) terminals. WARNING! Make sure that the booster cable connections are correct. COnnaCt the booster cable to the engine block as far as possible from the battery. 3. Starting engine 1) Turn the starting switch to START position and start up the engine.

2) If the engine doesn’t start at first. try again after 2 minutes or so. After the engine has started, the booster cables should be disconnected in the reverse order in which they were connected. 1. Disconnecting the booster cables 1) Disconnect the clip of booster cable B from 1 the engine block which was started. 2) Disconnect the other clip from the negative (-) terminal of the running engine. 3) Disconnect the clip of booster cable A from the positive (t) terminal of the running engine. 4) Disconnect the other clip from the positive (t) terminal of the engine which was started.