Cummins — REMOVAL AND INSTALLATION OF BATTERY

SAFETY AND OPERATION SECTION 3 Page 29 HANDLING OF BATTERY PRECAUTIONS FOR CHARGING BATTERY 1. Before charging, disconnect the cable from the negative (-) terminal of the battery Otherwise, an unusually high voltage will damage the alternator. 2. While charging the battery, remove all battery plugs for satisfactory ventilation. 3. If the electrolyte temperature exceeds 45”C, stop charging for a while To avoid gas explosions, do’not bring fire or sparks near the battery 4. Turn off the charger as soon as the battery is charged. Overcharging the battery may cause the following: 1) Overheating the battery 2) Decreasing the quantity of electrolyte 3) Damaging the electrode plate.

6 Do not mix up cables (positive (+) to negative (-) or negative (-) .o positive +)), as it will damage the alternator. 5. if the eiectrolyte gets on your skin or clothes, immediately wash ~!h plenty of clean water 7. When inspecting or servicing a battery, be sure to stop the engine and turn the starting switch key to position. 6 ‘&hen performing any service to battery besides checking the electrolyte level or measuring the Specific gravity, disconnect cables from the battery. REMOVAL AND INSTALLATION OF BATTERY - When removing battery, first disconnect the cable wth black tube from the ground (normally, from the negative (-) terminal).

If a tool touches a cable connecting the positive terminal and the chassis, there is danger of sparks being emitted. - When installing battery, the ground cable should be connected to the ground terminal as the IaSt Step. - The batteries are mounted on both side of the machine. The grounding cable is connected to the left side battery.