SERIES 60 SERVICE MANUAL 6. Press the drive gear onto the shaft until a clearance of 1.00 mm (0.039 in.) is obtained between the inner face of the gear and the pump body. See Figure 3-7. Figure 3-7 Oil Pump Drive Gear Installation NOTE: A minimum press load of 6.7 kN (1,506 lb) must be obtained when pressing the gear onto the shaft. When completed, an end play of 0.84-1.12 mm (0.033-0.044 in.) must be obtained. 7. Lightly coat the driven gear bushing with clean engine oil. 8. Insert the drive shaft and gear assembly into the pump body. See Figure 3-4. 9. Lightly coat both bushings in the pump cover with clean engine oil. 10. Index them with the shafts. 11.
Install the four cover bolts and hand-tighten. 12. Rotate the oil pump by hand. The oil pump must turn freely without binding. NOTICE: The cause of oil pump binding must be corrected before installation is complete or severe engine damage may result. 13. If binding occurs, stop assembly and disassemble until the cause can be detected and corrected. Refer to section 3.2.3. 14. Torque the four cover bolts to 30-38 N·m (22-28 lb·ft). 3.2.5 Assembly of Oil Pump (Pre-1991 Engines) Assemble the oil pump as follows: 1. Lightly coat the drive shaft bushings with clean engine oil. See Figure 3-7. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-15