Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

3.2 OIL PUMP 2. Insert the drive shaft and gear assembly into the pump body. 3. Position the oil pump assembly on a press, pump body down, supporting the drive shaft. The pump body should be free of the press bed supported by the pump gear contacting the bottom of the pump cavity. 4. Coat the bore of the drive gear with a light film of Lubriplate (or equivalent). 5. Position drive gear squarely on the end of the shaft. 6. Press the drive shaft until a clearance of 0.38 mm (0.015 in.) is obtained between the inner face of the gear and the pump body. See Figure 3-8. NOTE: A minimum press load of 8.9 kN (2,000 lb) must be obtained when pressing the gear on the shaft.

When completed, an end play of 0.25-0.51 mm (0.010-0.020 in.) must be obtained. 7. Lightly coat the driven gear shaft bushing with clean engine oil. 8. Insert the driven shaft and gear assembly into the pump body. See Figure 3-5. Figure 3-8 Oil Pump Drive Gear Installation (Pre-1991 Engines) 9. Lightly coat both bushings in the pump with clean engine oil. 10. Index them with the shafts. 11. Install the four cover bolts and hand-tighten. 12. Rotate the pump by hand. The oil pump must turn freely without binding. (Rev. 2005) All information subject to change without notice. 3-16 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION