Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 3.8.2 Removal of Oil Cooler Remove the oil cooler core and housing as follows: 1. Drain the cooling system by opening the drain cocks at the right rear of the cylinder block, and in the bottom of the water pump housing. 2. Disconnect the hose from the water pump at the lower neck of the oil cooler housing. 3. Match-mark the oil cooler core and housing to ensure correct reinstallation. 4. Remove the bolts that attach the oil cooler housing and core to the oil filter adaptor. 5. Place a pry bar between the oil cooler housing and cylinder block, just below the upper neck. Gently pry the oil cooler housing from the cylinder block and the oil filter adaptor. 6.

Use a gasket scraper or chisel and a fiber mallet or plastic hammer to separate the oil cooler core and housing. 7. Remove all traces of gasket material from the oil cooler and housing. 3.8.3 Cleaning of Oil Cooler Clean the oil cooler core prior to inspection as follows: 1. Remove the core from the oil cooler. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-53