SERIES 60 SERVICE MANUAL 3.10.3 Installation of Oil Dipstick Assembly Assemble oil dipstick assembly as follows: 1. Install dipstick adaptor into cylinder block. Torque to 22 N·m (16 lb·ft). See Figure 3-37. 1. Dipstick Gage 3. Copper Seal 2. Dipstick Tube Assembly 4. Adaptor Figure 3-37 Dipstick Adaptor with Seal 2. Insert the new copper seal and thread the oil gage tube assembly nut into the adaptor. 3. While holding the adaptor with a wrench, properly align the oil gage tube assembly. 4. Tighten the nut on the tube securely. 5. Install dipstick. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 3-73