Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

3.11 OIL PAN 3.11 OIL PAN The oil pan used on the Series 60 engine is made of plastic (epoxy vinyl ester) or aluminum. For engines built after April 1999, a one-piece bolt assembly is used with the improved plastic front sump and rear sump oil pans and a new isolator seal. The new isolator seal is reusable. See Figure 3-38. NOTICE: Old and new components should not be mixed. NOTE: Effective April 1999, all Series 60 engines are bulit with a reusable oil pan isolator seal. This seal does not need to be replaced at the time of removal provided there is not any damage observed. NOTE:

To expedite oil pan seal installation, use a soapy water solution to assist in installing the seal into the groove of the pan. When installing a new pan on an engine prior to serial number 6R490000 (built March 1, 1999), shift the pan toward the front of the engine (Rev. 2005) All information subject to change without notice. 3-74 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION