6.5 TURBOCHARGER (DIESEL) 6.5.3.2 Checking Wastegate Calibration Check the wastegate calibration as follows: NOTE: Turbochargers used on some engines do not have wastegates. 1. Remove hose from wastegate actuator. 2. Using DDC tool set, TLZ00100, set up an indicator at the end of the wastegate actuator adjusting rod to measure actuator rod travel. The indicator should have a minimum travel of 2.54 mm (0.100 in.). 3. Connect regulator and pressure gage setup to wastegate actuator. See Figure 6-21. Figure 6-21 Checking Wastegate Calibration (Rev. 2005) All information subject to change without notice. 6-34 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION