Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 6.6 TURBOCHARGER SERIES 60 NATURAL GAS (AUTOMOTIVE) ENGINE The Garrett GTA42 turbocharger is used on all Series 60G automotive engines. See Figure 6-23. NOTE: On April 2000, all Series 60 engines with GT40 and GT42 turbochargers were replaced by GTA40 and GTA42 turbos. The GTA turbo has a CHRA (center housing rotating assembly) with a boreless compressor wheel. 1. Compressor Housing 4. Wastegate Actuator 2. Actuator Hose 5. Turbine Housing 3. Water-cooled Center Housing 6. V-Band Joints Figure 6-23 GTA42 Turbocharger Assembly (Coach) The turbocharger is designed to increase the overall power and efficiency of the engine.

Power to drive the turbocharger is extracted from the energy in the engine exhaust gas. The CHRA consists of a turbine wheel and shaft, a compressor wheel, and a center housing that serves to support the rotating assembly, bearings, seals, a turbine housing, and a compressor housing. The center housing has connections for oil inlet, oil outlet, water inlet and water outlet fittings. The rotating assembly consists of a turbine wheel and shaft assembly, piston ring(s), thrust spacer, compressor wheel, and wheel retaining nut. The rotating assembly is supported on two pressure-lubricated bearings that are retained in the center housing by snap rings.

Internal oil passages are drilled in the center housing to provide lubrication to the turbine wheel shaft bearings, thrust washer, thrust collar, and thrust spacer. Internal water passages provide cooling and subsequent protection against oil cooking in the housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 6-43