SERIES 60 SERVICE MANUAL 6.6.2 Cleaning and Removal of Turbocharger (Series 60G Automotive Engine) Cleaning the turbocharger is not necessary before removal. PERSONAL INJURY To avoid injury from hot surfaces, wear protective gloves, or allow engine to cool before removing any component. Prior to removal, visually check for: 1. Missing or loose nuts and bolts. 2. Loose or damaged intake and exhaust ducting. 3. Damaged oil supply and drain lines. 4. Cracked or deteriorating turbocharger housings. 5. External oil leakage. 6. Damaged water supply and return lines. 7. Replace damaged parts with new parts. To remove the turbocharger, perform the following: NOTICE:
Do not attempt to remove carbon or dirt buildup on the compressor or turbine wheels without removing the turbocharger from the engine. If chunks of carbon are left on the blades, an unbalanced condition will exist and subsequent failure of the bearings will result if the turbocharger is operated. However, it is not necessary to disassemble the turbocharger to remove dirt or dust buildup. 1. Disconnect and remove the CAC ducting at the compressor housing. 2. Disconnect and remove the air inlet hose attached to the compressor housing. 3. Disconnect the exhaust outlet pipe from the turbine housing of the turbocharger. For proper operation, the turbocharger rotating assembly must turn freely.
Whenever the exhaust ducting is removed, spin the turbine wheel by hand. 4. Remove the inlet oil line from the top of the center housing. 5. Remove the oil drain line from the bottom of the center housing. NOTE: Be sure to drain coolant before removing water lines from bearing housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 6-49