6.6 TURBOCHARGER SERIES 60 NATURAL GAS (AUTOMOTIVE) ENGINE 6. Remove water lines from bearing housing. 7. Remove actuator return line on bottom port of actuator. 8. Attach a chain hoist and a suitable lifting sling to the turbocharger assembly. 9. Remove the nuts securing the turbocharger assembly to the exhaust manifold. Then, lift the turbocharger assembly away from the engine and place it on a bench. 10. Cover the end of the oil drain line, the oil outlet line, water supply, water return, the air inlet and the exhaust outlet openings on the engine and turbocharger to prevent the entry of foreign material.
PERSONAL INJURY To avoid injury from improper use of chemicals, follow the chemical manufacturer’s usage, handling, and disposal instructions. Observe all manufacturer’s cautions. 6.6.3 Disassembly of Turbochargers (Series 60G Automotive Engine) Disassemble the turbocharger as follows: NOTE: Clean the exterior of the turbocharger with a non-caustic cleaning solvent before disassembly. 1. Mark the related positions of the compressor housing, center housing and turbine housing with a punch or scribe to assure reassembly in the same relative position. NOTICE: Exercise care when removing the compressor housing and turbine housing to prevent damage to the compressor and turbine wheels. 2.
Loosen the V-band coupling securing the compressor housing to the backplate assembly and remove the compressor housing and V-band. (Rev. 2005) All information subject to change without notice. 6-50 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION