8.2 HYDRAULIC EGR VALVE NOTICE: The insulator shield must be replaced whenever the actuator assembly has been removed from the EGR valve assembly. Reuse of the insulator shield will damage the EGR assembly. NOTICE: The spline drive for the actuator assembly is keyed to ensure proper alignment with the shaft on the valve assembly. When performing step 1, do not force any components onto the splined shaft. If excessive force is used, the splined shaft will be damaged. 1. Install the hydraulic actuator assembly (5), heat shield (3), and new insulator shield (2) onto the splined shaft (7) of the EGR valve assembly (1). See Figure 8-21. 1. EGR Valve Assembly 4. Splined Internal Drive 6. Bolts 2.
Insulator Shield 5. Hydraulic Actuator Assembly 7. Splined External Shaft 3. Heat Shield Figure 8-21 EGR Hydraulic Actuator and Related Parts (Rev. 2005) All information subject to change without notice. 8-24 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION