SERIES 60 SERVICE MANUAL NOTICE: When performing step 2, apply torque evenly to the bolts to ensure that the EGR valve assembly and hydraulic actuator assembly are not misaligned. Misalignment will cause the assemblies to bind. 2. Install two bolts (6) through the hydraulic actuator assembly (5) to secure to the EGR valve assembly (1). Torque bolts (6) to 24-28 N·m (18-21 lb·ft). 8.2.4 Installation of Hydraulic EGR Valve Installation steps are as follows: 1. Place a new gasket (3) onto the EGR cooler (5). See Figure 8-22. 1. Nut 4. Stud 2. EGR Valve and Actuator Assembly 5. TSBF EGR Cooler 3. Gasket Figure 8-22 EGR Valve Assembly and Related Parts 2.
Properly align the EGR valve and actuator assembly (2) with studs (4) and install onto the EGR cooler (5). See Figure 8-22. NOTE: The EGR valve inlet tube should face the flywheel housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 8-25