SERIES 60 SERVICE MANUAL 2. Remove the four hose clamps (4) securing the Delta P tubes (5 and 9) to the Delta P Sensor (1). See Figure 8-36. 1. Delta P Sensor 6. Delta P Tube Fittings 10. Nut 2. Stud 7. Venturi Tube 11. Bracket 3. Isolator 8. P-Clips 12. Thermostat Housing 4. Hose Clamp 9. Delta P Tube 13. Bolt 5. Delta P Tube Figure 8-36 Delta P Sensor and Related Parts 3. Remove the Delta P tubes (5 and 9) from the Delta P Sensor (1) ports. See Figure 8-36. 4. Remove the two bolt securing the P-clips (8) and Delta P tubes (5 and 9) to the exhaust manifold. See Figure 8-36. Remove the clips. 5. Disconnect and remove the Delta P Tube fittings (6) from the venturi tube (7). See Figure 8-36. 6.
Remove two bolts (13) securing the Delta P Sensor (1) to bracket (11). See Figure 8-36. Remove the Delta P Sensor. 7. Remove the three nuts (10) and six isolators (3) securing bracket (11) to thermostat housing. See Figure 8-36. Remove the bracket. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 8-41