Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

9.4 CRANKING MOTOR 9.4 CRANKING MOTOR The cranking motor is bolted to the flywheel housing. See Figure 9-13. Figure 9-13 Cranking Motor Mounting NOTICE: To prevent excessive overrun and damage to the drive and armature windings, the switch should be opened immediately when the engine starts. A cranking period should not exceed 15 seconds without stopping to allow the motor to cool for at least 15 seconds. When the cranking circuit is closed, a drive pinion on the armature shaft engages with the teeth on the engine flywheel ring gear to crank the engine.

When the engine starts, it is necessary to disengage the drive pinion to prevent the armature from overspeeding and damaging the cranking motor. To accomplish this, the cranking motor is equipped with an over-running clutch within the drive pinion. The cranking motor drive pinion and the engine flywheel ring gear must be matched to provide positive engagement and to avoid clashing of the gear teeth. NOTE: Some engines may be equipped with air starters. Contact starter manufacturer for operating characteristics and rebuilding procedures.

The 42 MT cranking motor typically used on the engine has a nose housing that can be rotated to obtain a number of different solenoid positions with respect to the mounting flange. The commutator end cap can be removed to inspect the brushes, in most cases, without removing the cranking motor from the vehicle. (Rev. 2005) All information subject to change without notice. 9-26 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION