Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL The cranking motor armature is supported by three sintered bronze bearings located, one each, in the nose and intermediate housings, with one in the commutator end cap. See Figure 9-14. 1. O-ring 10. Shift Mechanism (Totally Enclosed) 2. End Cap (Removal for Inspection) 11. Two-piece Housing 3. Bronze Bearing 12. O-ring 4. Connector Strap 13. Shaft 5. Gasket 14. Heavy-duty Drive Overrunning Clutch 6. Low Friction Bushing 15. Shaft 7. Seamless, One-piece Solenoid Case 16. O-ring 8. O-ring 17. Shaft Seal 9. Sealing Boot 18.

One-piece Brush Figure 9-14 Typical Cranking Motor Cross-section Sintered bronze bearings used in the current cranking motors have a dull finish, compared to the former machined, cast bronze bearings, which had a shiny finish. The cranking circuit may contain a key start switch or push switch (or both), a relay, magnetic switches, solenoids, oil pressure switch, fuel pressure switch, and other protective devices. For the complete cranking circuit, refer to the vehicle manufacturer's wiring diagram. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 9-27