SERIES 60 SERVICE MANUAL 9.4.1 Repair of Cranking Motor Refer to the OEM guidelines for cranking motor repair procedures. 9.4.2 Removal of Cranking Motor Precleaning is not necessary. Remove the cranking motor as follows: ELECTRICAL SHOCK To avoid injury from electrical shock, follow OEM furnished operating instructions prior to usage. 1. Remove the ground strap or negative cable(s) from the battery(s). 2. Tag each lead to ensure correct connections when the cranking motor is reinstalled. 3. Disconnect the cranking motor cables and solenoid wiring. 4. Support the motor, and remove the three bolts which secure it to the flywheel housing. 5.
Pull the motor out to remove it from the flywheel housing. If the nose housing requires relocation, perform the following steps: The solenoid should not be located below the centerline of the cranking motor. Dust, oil, moisture and foreign material can collect and cause solenoid failure. NOTICE: 1. Remove the six socket-head screws (one short and five long) and six neoprene plugs from the unused holes if a twelve-hole mounting flange is used. 2. Turn the nose housing to the required position. 3. Install the six socket-head screws, with the short screw in the shallow hole nearest the solenoid and six neoprene plugs, if a twelve hole mounting flange is used. 4.
Torque the screws to 18-23 N·m (13-17 lb·ft). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 9-29