INSTALLATION GUIDELINES FOR ALLIED SIGNAL®-BENDIX® AIR COMPRESSOR TF-550 AND TF-750 Installation guidelines for Allied Signal®-Bendix® air compressor are as follows: Compressor Discharge Line Avoid installing valves (pressure regulator valves, etc.) in the compressor discharge line between the compressor, and reservoir or air dryer. The valves can trap water and lead to discharge line freeze-up during cold temperature conditions. The longer the discharge line length, the greater the potential for a frozen discharge line to occur. Compressor discharge line lengths are listed in Table 11-1. * Last three feet including reservoir or air dryer supply port fitting must be insulated with 1/2 in.
thick closed cell polyethylene Use of larger I.D. discharge line will further reduce the chances of freeze-up in extreme cold weather conditions and should be pipe insulation. considered for "cold weather package" applications. Table 11-1 Discharge Line Length and Diameter (Low Duty Cycle Applications) NOTE: High duty cycle application with lengths of 3.05 - 4.88 m (10.0 - 16.0 ft) should use a 12.7 mm (0.5 in.) I.D. discharge line. NOTE: If the actual application requires the discharge line length to fall outside the specified ranges given, it is recommended that Allied Signal® TBS Engineering department be contacted.
Discharge Line Material If a copper discharge line is used, a flexible connection to the first reservoir or air dryer should be added to prevent fatigue of the copper line. Wire-braided Teflon® hose must have a minimum operating temperature of 232°C (450°F) and a working pressure of 10.0 bar (150 psi) if connected directly to the compressor discharge fitting. Discharge Line Slope The discharge line should slope continuously downward from the air compressor discharge port, with no sharp bends, water traps, risers or elbow fittings, to the first reservoir or air drying device.
If there are any upward or downward deviations, the line can trap water, which can freeze during cold weather, causing a blockage. Compressor damage can occur as a result of a blocked discharge line. (Rev. 2005) All information subject to change without notice. 11-26 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION LENGTH I.D. MIN. 1.83 - 2.90 m (6.0-9.5 ft) 2.90 m - 3.66 m (9.5-12 ft)* 2.90 m - 3.66 m (9.5-12 ft)* 12.7 mm (0.50 in.)† 3.66 - 4.88 m (12-16 ft)* 15.88 mm (0.625 in.)