Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.4.5 Removal of Intake and Exhaust Valve Seat Insert As the intake and exhaust valve seats are different in size, two different tools are required for removal. Use the cam-operated valve seat remover (J–23479–460A) with collet (J–23479–100A) to remove the larger intake valve seat insert. Use valve seat remover (J–23479–271) with collet (J–23479–29) to remove the smaller exhaust valve seat insert. See Figure 1-76. 1. Collet 4. Valve Seat Insert Puller 2. Knurled Knob 5. Collar 3. Spring 6. Collet Lever Figure 1-76 Valve Seat Insert Removal Tools Remove the intake and exhaust valve seats as follows: 1.

Place the cylinder head in a horizontal position with the valve seats facing up. NOTICE: Follow instructions supplied with tools (J–23479–460A, J–23479–100A, J–23479–271, and J–23479–29) to ensure longer tool life and unnecessary collet damage. 2. Using a new valve seat insert as a guide, turn the knurled knob on the end of the shaft to tighten and expand the collet until the valve seat insert will just slip off the collet. Refer to instructions supplied with the valve seat remover tool for correct tool operation. 1.4.5.1 Inspection of Valve The valve stems must be free from scratches or scuff marks, and, the valve faces must be free from ridges or cracks.

Some pitting of the valve face is normal, and is acceptable as long as no leak paths are evident. If leak paths exist, reface the valves or install new valves. If the valve heads are warped or the valve stem is bent, replace the valves. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-91