1.4 VALVES, SPRINGS, GUIDES, INSERTS, SEALS AND ROTATORS 1.4.6 Installation of Intake and Exhaust Valve Seat Insert Perform the following steps for intake and exhaust valve seat insert installation: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Clean the seat insert counterbores and the new seat inserts with a suitable solvent and blow dry with compressed air. 2. Use valve seat insert installers (J–33190) (intake) and (J–34983) (exhaust), to install new inserts. See Figure 1-79. Figure 1-79 Valve Seat Insert Installation Tools (Rev.
2005) All information subject to change without notice. 1-94 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION