SERIES 60 SERVICE MANUAL 1.4.5.2 Inspection of Valve Springs Inspect the valve springs and replace any that are pitted or cracked. The entire spring should be inspected. When a broken spring is replaced, the rotator and valve locks for that valve and spring should also be replaced. Use valve spring tester (J–22738–B) to test the springs. See Figure 1-78. Figure 1-78 Testing Valve Spring If the spring load is less than 280 N (63 lb) at a compressed length of 67.25 mm (2.648 in.), the spring should be replaced and the valve locks should be discarded. 1.4.5.3 Inspection of Valve Guides Inspect the guides for cracks, chipping, scoring or excessive wear.
Measure the valve guide bore with a small hole gage or gage pin, and measure the valve stem diameter with a micrometer. Compare the measurements to determine valve stem clearance. If the clearance is greater than 0.152 mm (0.006 in.), the valve guide must be replaced. 1.4.5.4 Inspection of Valve Seat Inserts Inspect valve seat inserts for wear, cracking or incorrect seat angle, which should be 31 degrees, standard valve seat insert thickness. See Figure 1-66. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-93