Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.4 VALVES, SPRINGS, GUIDES, INSERTS, SEALS AND ROTATORS 7. The valve head recess depth from the firedeck is increased by valve and/or insert grinding. It should be checked with a sled gage (J–22273–A) (or equivalent). See Figure 1-85. Figure 1-85 Measuring Valve Head Recess Depth [a] If the diesel intake exhaust valve head recess depth is not between 1.4 to 1.8 mm (0.055-0.071 in.), the valve and seat must be replaced. [b] If the gas intake valve head recess depth is between 0.79 to 1.17 mm (0.031-0.046 in.), the valve and seat are correctly installed.

[c] If the gas exhaust valve head recess depth is not between 0.976-1.4 mm (0.030-0.053 in.), the intake 0.79-1.17 mm (0.031 -0.046 in.) valve and seat must be replaced for the Series 60G engine. 8. After light clean-up, thoroughly clean the valve seat with fuel oil and blow dry with compressed air. Check seat-to-valve face contact by applying a light coat of Prussian Blue (or equivalent) to the valve seat land. Insert the valve in the guide and "bounce" the valve head on the seat insert without rotating the valve. A full 360° contact line should appear approximately centered on the valve face. (Rev. 2005) All information subject to change without notice.

1-98 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION