SERIES 60 SERVICE MANUAL 1.4.7 Installation of Valve Guide Perform the following steps for valve guide installation: NOTE: Valve guides are not replaceable on natural gas. 1. Start the chamfered end of the valve guide into the cylinder head from the top. See Figure 1-86. Figure 1-86 Valve Guide Installation 2. Insert the driver into an air chisel. Insert the driver into the valve guide limiting sleeve (J–33191–A) and install this assembly over the valve guide. Drive the guide into the cylinder head until the driver bottoms in the limiting sleeve. See Figure 1-87. Figure 1-87 Valve Guide Installation All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-99