Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.4 VALVES, SPRINGS, GUIDES, INSERTS, SEALS AND ROTATORS 3. Properly used, the installer ensures the correct protrusion of the valve guide from the cylinder head of 37.75 mm (1.486 in.). 1.4.8 Installation of Valve, Spring, Seal and Rotator Perform the following steps for valve installation: 1. Position the cylinder head vertically on the overhaul stand. Lubricate the valve stems with clean engine lubricating oil and slide them into their respective valve guides and against the valve seats. If reusing valves, install them to their original positions. 2. Install the valve spring seat over the valve guide. Install the valve stem oil seals using valve stem oil seal installation tools.

See Figure 1-88. 1. Valve Stem Seal Installer 4. Valve Guide 2. Oil Seal Protector Cap 5. Valve 3. Valve Spring Seat 6. Valve Stem Oil Seal Figure 1-88 Valve Stem Oil Seal Installation Tools (Rev. 2005) All information subject to change without notice. 1-100 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION