14.7 CLEANING CONTAMINATED LUBRICATION OIL SYSTEM 14.7 CLEANING CONTAMINATED LUBRICATION OIL SYSTEM If coolant should leak into the lubrication system, the lube system must be thoroughly flushed to avoid or limit damage using the flushing procedures outlined below. 14.7.1 Before Flushing Lubrication System The following steps must be followed before flushing the contaminated lubrication system: 1. Determine the cause of the internal coolant leak and correct the problem. 2. Thoroughly drain the lubricating oil. Take and label a representative 6-8 ounce sample for chemical analysis. 3. Examine the drained oil:
[a] Refer to section 14.7.2 if the oil is still reasonably fluid and is typical of the used oil at regular drain intervals. [b] Refer to section 14.7.3 if the oil shows a gelling texture. 4. Inspect main bearing shells: [a] If damaged, the engine must be disassembled and checked for any additional damage. [b] If not damaged, proceed as follows: Refer to section 14.7.2 if the oil on the bearing shell(s) is viscous with normal flowing texture Refer to section 14.7.3 if the oil on the bearing shell(s) has gelled up, requiring scraping to remove. (Rev. 2005) All information subject to change without notice. 14-50 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION