SERIES 60 SERVICE MANUAL 14.7.2 Flushing a Non-Gelled Oil System Use this procedure if the contaminated lubricating oil is still freely flowing without gelling. This requires the lubricating oil recommended for normal operation. FIRE To avoid injury from fire caused by heated diesel-fuel vapors: Keep those people who are not directly involved in servicing away from the engine. Stop the engine immediately if a fuel leak is detected. Do not smoke or allow open flames when working on an operating engine. Wear adequate protective clothing (face shield, insulated gloves and apron, etc.). To prevent a buildup of potentially volatile vapors, keep the engine area well ventilated during operation. 1.
Remove and discard the oil filter and replace with new filters. 2. Pressure fill the lubricating system to 172 kPa (25 psi) with the lubricating oil recommended for normal operation, making sure the crankcase is filled to the proper operating level. Refer to section5.2 of the engine service manual. PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 3.
Start and run the engine at fast idle (1000 to 1200 rpm) for 30 minutes to one hour. Check engine running conditions frequently, especially the oil pressure, and stop immediately if a reading is out of range. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 14-51