16.7 IGNITION COIL HARNESS 16.7.3 Installation Ignition Coil Harness Install the ignition coil harness as follows: 1. Press the connectors of the ignition coil harness onto the four ignition coils. 2. Connect the ignition coil harness to the igniter module. 3. Connect the ignition coil harness to the 12-volt power supply. 4. Connect the ignition coil harness to the ECM. 5. Attach the harness clips to the rocker cover and cylinder block. 6. Add antisieze compound to the two coil cover mounting screws to aid removal in the future. 7. Install the coil cover on the rocker cover with the two Phillips mounting screws. (Rev. 2005) All information subject to change without notice.
16-14 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION