SERIES 60 SERVICE MANUAL 16.8 SPARK PLUGS The condition of the spark plug determines the high voltage level and is the single most important component in the ignition system. The size of the electrode gap, condition of the electrodes, and the amount of deposits on the electrodes all affect the life of the spark plug. The electrodes of the spark plug are made from platinum or iridium which will minimize electrode wear. Replace the spark plug with a new one if the electrode wear and amount of deposits are excessive. Otherwise the spark plug can be regapped to 0.381 mm (0.015 in). NOTE: Servicing of the spark plugs should take place while the engine is cool.
This will facilitate easier removal of the spark plugs and reduce the possibility of the plug sticking in the spark plug insert contained in the cylinder head; this also ensures the correct torque and eliminates damage to the spark plug and gasket during installation of the plugs. 16.8.1 Removal of Spark Plug Remove the spark plug from the cylinder head as follows: 1. Remove the ignition coils. Refer to section 16.3.1. 2. Remove the plug using a 5/8 in. thin wall spark plug socket and appropriate extensions. 16.8.1.1 Cleaning of Spark Plug Terminal, Ceramic Insulation, and Socket Area Clean the spark plug terminal, ceramic insulation, and spark plug socket as follows:
EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Remove dirt and debris with compressed air. 2. Remove oil and grease deposits. 3. Inspect the spark plug. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 16-15