Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.6 ROCKER COVER The rocker cover completely encloses the valve and injector operating mechanism on top of the cylinder head (and in some cases an engine brake), including the overhead camshaft. Depending on the installation, the rocker cover may be a one-piece, two-piece or three-piece design, see Figure 1-102. The one-piece rocker cover is molded of a sound-dampening, fiberglass-reinforced, synthetic material. It is internally ribbed to distribute the hold-down bolt clamp load for effective, full perimeter sealing. See Figure 1-100. Effective July 1993, a breather baffle is installed on the low-profile aluminum rocker cover. NOTE:

Effective May 1999, all Series 60 engines are built with a reusable rocker cover gasket. This gasket does not need to be replaced at the time of removal provided there is not any damage observed. 1. Gasket 5. Cover Plug 2. Rocker Cover 6. Bolt 3. Isolator 7. Element 4. Washer 8. Clip Figure 1-100 One-piece Rocker Cover - Series 60 Diesel Engine All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-111