1.6 ROCKER COVER The two-piece rocker cover is constructed of cast aluminum. The top piece or cap is held in place by eight bolts and is removable for access to the valve, engine brake and fuel injector adjusting mechanisms. A one-piece diamond shaped perimeter seal is located in a groove in the rocker cover base and seals the cap to the base. See Figure 1-103. 1. Limiting Sleeve 5. Rocker Cover Cap 2. Isolator 6. Diamond-Shaped Seal 3. Washer 7. Rocker Cover Base 4. Bolt 8. Isolator Rim Seal Figure 1-103 Two-piece Rocker Cover (Rev. 2005) All information subject to change without notice. 1-114 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION