Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL The three-piece rocker cover is similar to the two-piece cover but with an additional intermediate cover and diamond seal and new cover cap. See Figure 1-104. 1. Limiting Sleeve 6. Rocker Cover Cap 2. Isolator 7. Bolt 3. Washer 8. Intermediate Cover 4. Bolt 9. Rocker Cover Base 5. Bolt Figure 1-104 Three-piece Rocker Cover Two caps are available with the Series 60 diesel engines. One is for use with a Jake Brake®, and one without a Jake Brake®. Only one cap is available with the Series 60G engines. The rocker cover base is attached to the cylinder head using ten assemblies consisting of a bolt, limiter sleeve, isolator and flat washer.

All rocker covers use a silicone rim seal, seated in a groove around the bottom edge of the rocker cover base to provide an effective oil seal. The one-piece and two-piece design rocker covers incorporate a crankcase ventilation breather outlet. The three-piece design and the Series 60G cap incorporate a combination filler/breather at the camshaft cover (gear case cover) position. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-115