1.6 ROCKER COVER 1.6.3 Removal and Cleaning of Two-piece Rocker Cover For Diesel Engines Only Preclean the two piece rocker cover, especially around its seat on the head, and in the attaching bolt recesses, to keep dirt and debris out of the valve operating chamber. Perform the following steps to remove the two-piece rocker cover: 1. Remove the eight screws that attach the rocker cover cap to the base. 2. Lift the cap off the base. 3. Loosen and remove the ten bolt and isolator assemblies that attach the base to the cylinder head. 4. Lift the base straight up off the cylinder head.
1.6.3.1 Inspection of Two-piece Rocker Cover Perform the following steps to inspect the two-piece valve rocker cover which has a removable breather housing: 1. Remove the three screws and retainer that retains the breather housing. See Figure 1-106. 2. Remove the breather housing, seal, and wire mesh element. 3. Wash the components in clean fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 4. Blow dry with compressed air. (Rev. 2005) All information subject to change without notice. 1-118 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION